![]() Reinstalled 4644 while unplugged from The Internet and now everything is working again. Used DDU to completely remove every hardware driver - the Intel IGP, the A770, and a little RTX 3060 cruft left over as well. Destiny 2 performance says the Arc card was running on 4644, but something about the two Intel GPUs must've been confusing the Bifrost and Arc Control software. DDU revealed the problem - the Bifrost driver listed was 4125, while the UHD driver listed was 4644. On my system, I had the IGP still enabled on the 12600K (rumor has it you need that for Vulkan ReBAR to function). Fan control also stopped working via Arc Control. Removing and reinstalling the Bifrost utility did not work. Games ran fine, but I noticed I had lost RGB and fan control via the Predator Bifrost utility. I installed 4644 on my 12600K/Bifrost system. Maybe a free trade-in for a battlemage whenever that headache comes out. Seems like Intel should be paying us instead of the QA team at this point. It's something like that but it's not really my job to figure out the issue. speeds in between the nodes are either zero or whatever the previous node is. It's acting like the nodes set in the fan curve settings are the only states the fans can be in, i.e. ![]() When I'm working, the card is very distracting. I think it's reasonable for people to instinctively download driver updates for these cards, because they're still far from perfect, and so far things have only been improving with updates. Games have been crashing and I've even had a couple full system hangs since the last update. I wish I had found this post before updating. I was, however, able to get SSU to work, so I have attached the file from that to this post. The fan spins up to full speed momentarily every five seconds or so, and adjusting the fan curve doesn't make a difference overall. I have the same card and issues as the other users above.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |